Hello.
Similar experience here but I have kept the beta installed. I don't
really had the need for the tick marks.
Only scare when installing was the screen when all gray and couldn't
read any instructions on
the screen. It turns out that the default contrast is 50%.
So after installation, I preformed the contrast adjustment under the
chassis.
gud luck
Fernando N2FQ
Michael Zeglen wrote:
I finially decided to upgrade my Orion to the latest firmware and decided to load the beta version. Everything went great but I noticed that I had lost the tick marks from the band scope and there was no way to change the sweep range. Everything else seemed to work fine. Did I miss something? Is this normal for this beta version? Was is a bad download? No indications of a bad download as the program finished up and radio seemed fime in all aspects except the broad range non-marked scope function. I have now down load version 2.062a into the radio and the scope markings are back and able to adjust the scope band width from the system menu. Does anyone have any constructive, supportive comments? I love and support Ten Tec and all they do so don't send me an email running them down. KL7ai - Alaska
_________________________________________________________________
Hotmail: Trusted email with Microsoft’s powerful SPAM protection.
http://clk.atdmt.com/GBL/go/196390706/direct/01/
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|