Re: [TenTec] Orion 2 - encoder clicks in the speaker or head phoneswhen turned

["pfizenmayer" <pfizenmayer2@q.com>]

Kevin - Check your Filter tap settings

MENUS>FILTER>DSP FILTER LENGTH> set it to 199 and see if it goes away .

73 Hank K7HP

> the radio back in about two weeks with an  explanation that they could not
> duplicate the issue; however they had replaced a  couple of capacitors as 
> a
> precaution. Well that didn't fix the problem. After a  few more weeks of
> getting to know the Orion 2 I noticed an additional  issues that might be
> related. When the bandwidth/filters are set to it  minimum setting (only 
> checked
> in CW mode) and then return to some setting above  1500 or so, the audio
> becomes distorted with a high pitched ring. The problem  will resolve 
> itself if
> the rig is cycled off and then on again. I have been a  Ham for many 
> years,
> and have had many rigs, but this is my first SDR  radio. Are all these
> things normal? Is it something that the new firmware will  fix?
> Any guidance would be greatly appreciated.
>
> Thanks,
> Kevin Santine - N5FXV
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec