Hi all...a little off the Ten Tec groups, but...
I have an MFJ 259B that I use and am a little confused about the R and X
readings...
I am trying to determine the true losses of my 235 ft horizontal loop, fed
with 600 ohm ladderline, then to a 4 to 1 voltage balun outside the shack.
SWR seems reasonable..below 3.8 to 1 80 thru 10 meters with the exception of
60 meters.
I run about 15 ft of good quality coax to the shack.
I also run 450 ohm feeders to the shack and a johnson matchbox to compare
signal levels...and to be honest, I can't tell much difference on transmit
nor recieve....except the signal to noise is a bit better with the balun vs
the matchbox.
I have tried 4 to 1 and 1 to 1 current baluns, but the voltage balun gives
me better matching.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|