Dave
Wonder if the bleeder changed value?
Any other resistors change value ( aged)?
Ron
K3MIY
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of DAVID HELLER
Sent: Monday, March 15, 2010 12:48 AM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] power problem on 0mni six
A slightly annoying problem has shown on my 0mni 6 + 961 PS.
Rig works perfectly unless I turn off AC power and try to restart
immediately or within about 10 minutes: The power supply goes into
motorboat mode, cycling about 5 Hz.. Makes no difference whether it's off by
switch on rig or PS - of course the two switches are essentially series'd
so shouldn't make any difference. If I leave power off a while it starts
and runs quite normally. Any suggestions before I put the scope to work?
Dave K3TX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|