You need an SDR that is capability of making a panadapter screen using
powerSDR. This requires a Flex radio of some type. I believe SoftRock
radios will also work. The key is they must be capable of being controlled
with powerSDR. Unfortunately, the rx320D will not work for this although
you can still use the rx320 to produce a low resolution spectrum display
with the Omni VII or Jupiter.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Richards" <jruing@ameritech.net>
To: "N4PY2" <n4py2@earthlink.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Sunday, March 21, 2010 6:29 PM
Subject: Re: [TenTec] new N4PY software question.
Can one use a TT 320D receiver with an Omni VII and get the panadapter
function? Or will we be left with the original standard N4PY band
scope feature ? - ( which I thought was cool enough on its own... )
========================= K8JHR ==============================
On 3/21/2010 2:42 PM, N4PY2 wrote:
Yes, my N4PY software can link any radio supported with N4PY software to
any
SDR radio that works with PowerSDR.
==============================================================
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|