Re: [TenTec] Corsair II Vfo Molex Jumper

[Bwana Bob <wb2vuf@verizon.net>]

I didn't know that they were available with gold pins. That would help 
because the pins in mine seem to develop oxidation which causes the PTO 
to shift frequency.
                                73,

                                Bob WB2VUF

Dr. Gerald N. Johnson wrote:
> Shipping compared to the cost of the parts will shock you! Go with the 
> gold pins to help that shock a little.
> 73, Jerry, K0CQ
>
> On 3/21/2010 1:02 PM, gsanderlin wrote:
> > Thanks Jerry!
> >
> > Will order tomorrow..  I had requested that info from Tentec.  The guy spoke 
> > with in tech support said they didn't have any and did'nt have part numbers
> >
> > -----Original Message-----
> > From: Dr. Gerald N. Johnson<geraldj@weather.net>
> > Sent: Sunday, March 21, 2010 13:56
> > To: tentec@contesting.com
> > Subject: Re: [TenTec] Corsair II Vfo Molex Jumper
> >
> > Molex 03-06-2092 or 03-06-2091 with male pins 02-06-2103 or 02-06-6103.
> > 9 pin plugs with .062" male pins. Prefix these numbers with 538- for
> > Mouser catalog numbers.
> >
> > 73, Jerry, K0CQ
> >
> > On 3/21/2010 11:49 AM, gsanderlin wrote:
> > > Does anyone have A Molex Jumper for the Corsair II to allow it to work, without 
> > > the VFO connected, or know of the molex part number for the housing and the 
> > > pins.
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec