Ralph -- mine does the same thing occasionally. Appears that frequency
counter is not getting the signal from the PTO (that may not be technically
correct.. .don't hold me to it). My solution is to tap the front panel with
my finger. Good sharp tap, but not enough to break it... Seriously, works
every time.
Proper solution is probably to open it up and reseat a board or two.
Give it a shot.
>> I have a stock Corsair II that has been idle for about 4 months due to
> >> some
> >> family health issues. I turned it on yesterday and found the display
> only
> >> reads 9.0000 or 91.0000 no matter what band you select. I know that
> there
> >> was a discussion about this some time ago but was unable to find the
> >> answer
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|