Art....
How much end play do you see in the encoder? If you push it all the wa in
and turn it, does it work properly? What about pulling it out to the outer
end of the end play? Does it work ok?
Not wanting to buy an encoder right away, I drilled an undersize hole in a
nylon washer and pushed it onto the shaft all way against the bushing, while
pulling out on the encoder shaft. This took out the end play and it works
OK now.
Phil C. Sr.
k4dpk
----- Original Message -----
From: "Arthur Lewis" <wa8vsj@ameritech.net>
To: <TENTEC@contesting.com>
Sent: Wednesday, April 14, 2010 5:49 PM
Subject: [TenTec] Jupiter Multi encoder
> My Multi dial has beome intermittent. It starts to work and goes back to
> the lowest level in all funtion modes. Has anyone had this problem and
> what if any was the fix? Will something like a tuner cleaner help? Is
> changing the encoder the only way out?
>
> Art WA8VSJ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|