The Corsair II uses BOTH 9 and 6.3 Mhz filters. Like all other Tentecs
with an IF that IF is at 9 MHz and the product detector runs at 9 MHz,
heterodyning to 6.3 MHz for those filters and back to 9 is how the
bandpass tuning works.
73, Jerry, K0CQ
On 5/1/2010 3:52 PM, Paul DeWitte wrote:
> All of the Ten Tec rigs did not use the same filters.
>
> My Omni C and I think my ArgosyII uses 9mhz filters and my Corsair IIs use
> 6.3 mhz filters.
>
> Paul
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|