[Top] [All Lists]

Re: [TenTec] Paragon - easy to work on?

To: tentec@contesting.com
Subject: Re: [TenTec] Paragon - easy to work on?
From: Ben Hall <kd5byb@kd5byb.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 27 May 2010 07:23:39 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On 5/26/2010 10:13 PM, Bwana Bob wrote:
> The front panel is on hinges. Take off the top and bottom covers.  There
> will be a screw on each side of the front panel. Remove these 2 screws
> and the panel will swing down, giving you access to the pots. Be careful
> not to put any strain on the potentiometer leads, or the phenolic on the
> back of the pot will break.

Hi Bob,

THANKS MUCH for posting this!  Last night I was able to get a little 
Deoxit into the RF gain pot but was really struggling with how I was 
going to access the other pots.  This will make it much easier and I 
really appreciate it!

thanks much and 73,
ben, kd5byb
Ben Hall, kd5byb@kd5byb.net - ALWAYS OUTNUMBERED, NEVER OUTGUNNED.
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>