Can this keyer be set in both mode A and mode B? If so, make sure you are
in Mode B. Mode A does not have a dot memory.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Steve Thorne" <steve.thorne@att.biz>
To: <tentec@contesting.com>
Sent: Friday, July 02, 2010 10:54 PM
Subject: [TenTec] KEYER KR20A
> KEYER IS INTERMITTENTLY FAILING TO CREATE A DOT FOLLOWING A DASH
> EVEN THOUGH THE DOT PADDLE HAS BEEN PRESSED..
> CAN FIND NO DOCUMENTATION ON LINE RE THE KR-20A.
> ANYBODY GOT ANY DOCS THEY COULD FORWARD?
> TNX
>
> DE
> K9LLI
> --
>
> Steve Thorne
> steve.thorne@att.biz <mailto:steve.thorne@att.biz>
> 815 399-9161 Home
> 815 494-4827 Cell
> -----------------------------------------
> IMPORTANT: The sender intends that this electronic message is for
> exclusive use by the person to whom it is addressed. This message
> may contain information that is confidential or privileged and
> exempt from disclosure under applicable law. If the reader of this
> message is not an intended recipient, be aware that any disclosure,
> dissemination, distribution or copying of this communication, or
> the use of its contents, is prohibited. If you have received this
> message in error, please immediately notify the sender of your
> inadvertent receipt and delete this message from all data storage
> systems. Thank you.
>
> --
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|