| To: | vinsantis@sbcglobal.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] installing ladder line |
| From: | John Hill <n9rlojrh@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 7 Nov 2010 16:28:18 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Also remember to keep it off the ground. Ladder line works great. Almost no loss. 73, John N9RLO On Sun, Nov 7, 2010 at 3:36 PM, Vince Santis <vinsantis@sbcglobal.net>wrote: > Can 450 ohm ladder line be bent at 90 degrees around obstructions? > > Vince Santis, N1vs > > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec > -- N9RLO John Hill _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] installing ladder line, Rick - NJ0IP / DJ0IP |
|---|---|
| Next by Date: | [TenTec] The Ten-Tec Jupiter # 538 is SOLD., al sirois |
| Previous by Thread: | Re: [TenTec] installing ladder line, Rick - NJ0IP / DJ0IP |
| Next by Thread: | Re: [TenTec] installing ladder line, steve r |
| Indexes: | [Date] [Thread] [Top] [All Lists] |