TenTec
[Top] [All Lists]

Re: [TenTec] Computer Interface

To: tentec@contesting.com
Subject: Re: [TenTec] Computer Interface
From: Jim Brown <k9yc@audiosystemsgroup.com>
Reply-to: k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 06 Dec 2010 08:49:59 -0800
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On 12/5/2010 7:03 AM, Hank Garretson wrote:
> Absolutely none!  Save your money.  Run RS-232 from computer to Omni.  Run
> audio-in and out from Omni to computer sound card.  Build a one-transistor
> CW interface.

YES!  I ran a simple interface like Hank describes with my Omni V with 
the N4PY mod, and it worked VERY well.  I used it with WriteLog, but it 
would work with any good logging or control program.  All you need is a 
cable wired with the right pins on the right connector on both ends. I 
also used it with Ham Radio Deluxe.

Study the OmniV manual. For radio control, you only need the wires that 
go to pins 2, 3, and 5 on the DB9. To send CW, you also need pin 4 and 
pin 5 to the single transistor interface.

See http://audiosystemsgroup.com/HamInterfacing.pdf    This doesn't talk 
about the OmniV specifically, but the only difference is that the Omni V 
has the older style 25-pin connector. And, of course, set the 
logging/control program as Carl recommends.

73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>