TenTec
[Top] [All Lists]

Re: [TenTec] ant

To: tentec@contesting.com
Subject: Re: [TenTec] ant
From: Neal Laugman <neal.laugman@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 14 Jan 2011 18:44:07 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
My bad - I did mean polystyrene, but I was under the impression
the Airdux coil had a denser plastic.

-- 
Neal, NL7VL
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
On Fri, 14 Jan 2011 13:55:54 -0600
"Dr. Gerald N. Johnson" <geraldj@weather.net> wrote:

> I don't recall significant differences between Airdux and B&W other
> than the color of the box. I still have some of both. And they were
> made by melting a hot wire into the plastic, most likely NOT nylon,
> delrin, or polycarbonate (Lexan) more likely polystyrene because of
> its better RF characteristics at the cost of temperature sensitivity.
> I'm sure I have catalogs for each.
> 
> 73, Jerry, K0CQ
> 
> On 1/14/2011 1:00 PM, Neal Laugman wrote:
> > Airdux is the stouter of the two - but still plastic - maybe a
> > nylon or delrin, but not polycarbonate like miniductor.
> >
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>