I should of said omni 7 not 6
-----Original Message-----
From: ROD
Sent: Sunday, January 30, 2011 10:27 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Eagle owners......TX SSB bandwidth?
that is why I got the omni 6
-----Original Message-----
From: John
Sent: Sunday, January 30, 2011 5:05 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Eagle owners......TX SSB bandwidth?
It appears that the TX bandwidth is fixed at 2.4 KHz? So, there is no
capability to control TX low and high end cuts? IE, you cannot set the TX
bandwidth for 200-3000 Hz, etc?
Thanks and 73 John W4II
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|