Rod
If your rig has passband tuning, and the offending signal is low in pitch,
adjust the PBT to accentuate the highs; it it is high in pitch, go the opposite
direction; play with your toy a little 73
Ron
K3MIY
Quoting ROD <w3krq@dejazzd.com>:
> yes but I need it when I have a carrier next door to me. And is it not what
> the AN is for.
>
> -----Original Message-----
> From: N4PY2
> Sent: Monday, January 31, 2011 9:43 PM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] auto notch
>
> Turn it off.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Hays, NC 28635
> www.n4py.com
>
>
> ----- Original Message -----
> From: "ROD" <w3krq@dejazzd.com>
> To: <TenTec@contesting.com>
> Sent: Monday, January 31, 2011 9:13 PM
> Subject: [TenTec] auto notch
>
>
> > what is the fix for distorted audio when the auto notch is on at level 1
> > The kenwood radio did not distort audio when bc was on
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
-------------------------------------------------------------------
This mail sent through CSOnline Webmail http://webmail.csonline.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|