In step 4, when I release the LCK button, "BATTERY FAILURE" goes away, "SYSTEM
LOADING" appears and it asks me if I want to clear user memories. Then it asks
if I want to reseet filters. Then it displays "SYSTEM LOADING", then repeats
the questions again, and so the cycle begins. It never boots to 14.250.
Just for clarification, when the firmware finishes loading it immediately asks
me if I want to clear user memories. I hate to turn a "computer" off when it's
asking me a question but that's what I understand you are telling me I am to do
in order to do a RAM clear and Master reset.
> Date: Thu, 17 Feb 2011 16:13:27 -0500
> From: jhenry@tentec.com
> To: tentec@contesting.com
> Subject: [TenTec] When loading Orion 565 V2.064x11
>
> When updating to V2.064x11, it is recommended that after you upgrade
> the firmware, that you turn the rig off, and perform a RAM Clear reset
> followed by a master reset and clear user memories and filter
> settings.
>
> RAM clear is as follows:
> 1. Orion off, power supply on.
> 2. Press and hold the LCK button just below the VFO B knob.
> 3.Turn on Orion and continue to hold the LCK button until Master Reset is
> displayed on the screen. BATTERY FAILURE may also be displayed, disregard.
> 4. Release the LCK button and allow the Orion to boot to 14.250.
> 5. Turn the Orion Off and perform the Master Reset using The MAIN RX/TX
> button. User memories and filter settings MUST be cleared.
>
> THEN perform a Master Reset.
>
> John Henry
> TenTec Engineering
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|