I have one here I'll try to use tomorrow. I've been told it needs a separate
supply to work properly.
Mike, k5wmg
Pipe Creek, Texas
A thousand words a day. Five days a week. For life.
*
*
On Fri, Mar 4, 2011 at 11:02 PM, Billy Cox <aa4nu@ix.netcom.com> wrote:
> That's a good idea to try, another one would be to
> leave the mic/715/cable to rig inline and disconnect
> the power supply line ... see if anything changes?
>
> That might help to isolate the actual RF entry point.
>
> Hope that helps!
>
> 73 de Billy, AA4NU
>
>
> -----Original Message-----
> >From: Richards <jruing@ameritech.net>
> >Sent: Mar 4, 2011 10:25 PM
> >What happens if you coil the cable that runs between the715 and the
> >radio? Similarly if you introduce a coil in the mic cable to the 715?
> > Any help if you do this?
> >
> >Happy Trails.
> >======================= Richards / K8JHR =========================
> >
> >On 3/4/2011 10:16 PM, ROD wrote:
> >> I just received a ten tec 715 rf speech processor and I have rf for the
> first time at my station .It is there when I have it hooked to my orion does
> not matter if it isin or out I remove the mike from the 715 and hook it up
> to my orion no rf. any one else had trouble. 73 ROD
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|