TenTec
[Top] [All Lists]

Re: [TenTec] Default LCW BW 1000Hz

To: tentec@contesting.com
Subject: Re: [TenTec] Default LCW BW 1000Hz
From: John K3GHH <k3ghh@arrl.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 20 Mar 2011 13:44:48 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On 03/20/2011 12:48 PM, pfizenmayer wrote:
> By any chance do you have the RX>BW track or RX>PBT track turned on ? That 
> might be doing it .
>
> Hank K7HP
>
> ----- Original Message ----- 
> From: "John K3GHH" <k3ghh@arrl.net>
> To: <TenTec@contesting.com>
> Sent: Sunday, March 20, 2011 5:10 AM
> Subject: [TenTec] Default LCW BW 1000Hz
>
>
>> After a recent update of O2 firmware to 2.044A, when I first turn the
>> rig on its bandwidth (on LCW mode) is 1000 Hz. When I turn the rig off
>> the bandwidth is usually 500 Hz and often less --- certainly never
>> anything near as wide as 1000. How do I change this boot-up default
>> bandwidth?
>>
>> -- 
>> John K3GHH
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
Thanks, Hank... but they're both off.

-- 
John K3GHH

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>