1mm is very close to .040" the diameter of miniature tube pins. And of
18 gauge (AWG) copper wire. The difference is .00063" The difference
between 20 gauge copper wire and 0.8 mm is about the same. If the pins
are 20 gauge, which I doubt, it won't take much solder to make then .040
diameter.
73, Jerry, K0CQ
On 3/23/2011 3:48 PM, Barry N1EU wrote:
The 9Mhz filter in the Corsair II is soldered in. I want to install
socket pins to convert it to plug-in. Can anyone confirm that the
correct pin diameter is 1mm? There are both 1.0 and 0.8mm socket
pins available and just want to be sure.
Thanks& 73,
Barry N1EU
_______________________________________________
|