A wise decision. It is much more hassle to remove components when the board is
totally populated. Building in stages and testing as you go is a wise move.
fwiw
73, Jim wd4air
> Date: Sun, 15 May 2011 23:36:32 -0400
> From: jruing@ameritech.net
> To: tentec@contesting.com
> Subject: Re: [TenTec] Building TenTec Receiver 1254 Kit Question
>
> I was afraid someone would say that... so I waited.
>
> Common sense is not much fun... at least in the short run.
>
> Thanks for the uptake. I will build something else in the mean time.
>
> ------------------
> Happy Trails.
> ======================= Richards / K8JHR =========================
>
> On 5/15/2011 11:30 PM, William Miner wrote:
> > My advice would be to wait for your Elmer. The 1254 is a somewhat complex
> > kit if you are not an experienced builder. Doing the testing in stages can
> > save you from a lot of problems. Just my opinion. 73, Bill
> >
> _________________________________________________________________
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|