TenTec
[Top] [All Lists]

Re: [TenTec] OMNI 6 - Interesting problem Encountered during FD

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OMNI 6 - Interesting problem Encountered during FD
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 27 Jun 2011 23:09:39 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On Mon, Jun 27, 2011 at 10:57 PM, Don Jones <ko7i@comcast.net> wrote:
> As a side note, one CW, with a full load of filters in both IF's plus the
> INRAD roofing filter mod, I was able to run on the low end of 20 meter CW
> with the 20M SSB guys running too. I heard some interference but it was
> completely livable and I never lost  QSO do to overload. The OMNI 6's
> receiver held up just fine.

The Omni 6 is a fine radio with low phase noise.  In such a situation,
the Omni 6 receiver is also at the mercy of how much phase noise is in
that nearby ssb transmit signal.  So it's a credit to the transmitter
as well, assuming the antennas are in relatively close proximity.

73, Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>