Thanks Barry. Now I am confused. N4RS provided a pinout which is very
different from this. Could someone please clarify. Maybe there is more than
one configuration.
Joe
----- Original Message -----
From: "Barry N1EU" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, November 06, 2011 8:58 AM
Subject: Re: [TenTec] OMNI D Accessory Jack Pinout
> Here's what I'm seeing:
>
> 1. T (transmit control sig)
> 2. +REG
> 3. +13
> 4. REM VFO
> 5. LO
> 6. MUTE C
> 7. MUTE NO
> 8. GND
> 9. MUTE NC
>
> 73, Barry N1EU
>
> On Sun, Nov 6, 2011 at 1:46 PM, Joe <joe@n4yg.com> wrote:
>> I need to know the pinout of the 9-pin OMNI D accessory jack. I have
>> looked a several of the online manuals and everyone is missing the block
>> diagram which has this information. I am guessing that it is the same as
>> the Corsair II. If someone could give me the info or point me to a
>> complete manual I would appreciate it.
>>
>> Joe, N4YG
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|