[TenTec] Omni D PTO Swap

["Hulett, Russell" <rhulett1@consolidated.net>]

If I remove the entire PTO assembly from one Omni D and install in another, are 
there any adjustments needed other than the L1, L2, & L3 adjustments on the PTO 
to set the oscillator endpoints and linearity?  I have one rig with a smooth 
PTO but numerous "issues" otherwise, another with poor PTO but no "issues" 
otherwise.

Thanks in advance & 73, Curt KB5JO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec