| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] ORION 565 v3.025 Sweep Range |
| From: | John Henry <jhenry@tentec.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 4 Feb 2012 20:03:54 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Hello Barrett, No, the 565 has a fixed range sweep. I will note it and see if we can do it in the future. Thanks, John The photo on page 3 of the V3 Firmware Addendum (74474) shows the ORION II RX menu with a 'Sweep Range' option at the top of the list. On my ORION 565 running v3.025, my RX menu shows a 'Sweep Display' option in this menu position, with values of 'On' and 'Off'. Is there a way to adjust the sweep range on the 565/v3.025? 73, Barrett / KE4R _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] TenTec Digest, Vol 110, Issue 7, jack |
|---|---|
| Next by Date: | [TenTec] RX366 panadpter interface, Zivney, Terry |
| Previous by Thread: | [TenTec] ORION 565 v3.025 Sweep Range, Barrett Thompson |
| Next by Thread: | [TenTec] WTB Pegasus, Jeff Kelly |
| Indexes: | [Date] [Thread] [Top] [All Lists] |