To enter 1070Khz:
push VFOB ENTER
push 0-1-0-7-0
push VFOB ENTER
On Sun, Feb 5, 2012 at 6:37 PM, Zivney, Terry <00tlzivney@bsu.edu> wrote:
> WIth the RX366 subreceiver installed and V3.025 firmware, when I try to
> enter 1.070 MHz into
> VFO B which is asssigned to the subreceiver, I get a Frequency Not
> Supported message on the LCD.
> On my other Orion with the original subreceiver, the same keystrokes give
> me the local AM station
> using v1.372 (my gold standard for dx AM operation).
>
> On the right hand side of the LCD display where the graphics show the
> receive bandwidth,
> there is an overbar down from wide open down to 710 Hz; from 700 Hz down,
> the overbar
> (which shows the roofing filter selected on the main receiver)
> disappears. I have installed and
> selected the 600Hz filter in slot 2; the stock 2.4kHz filter is selected
> in slot 1.
>
> Terry Zivney N4TZ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|