| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] FILTERS FOR RX366 |
| From: | steve jobes <w1dxh@aol.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 12 Feb 2012 11:23:04 -0500 (EST) |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I purchased two optional filters to go into new rx366, question is what is proper direction to install filter? On each filter is 2 pins gold in color and two silver, which goes to the ground marking on circuit board? Am I correct in assuming that the filters would go f1 being std , f2 1800hz , then f3 600hz? Thanks for any assistance. 73, Steve W1DXH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Argonaut V S-Meter adjust, W4QG |
|---|---|
| Next by Date: | [TenTec] Jupiter - No transmit power output 10 meters, Karl Heimbach |
| Previous by Thread: | [TenTec] Argonaut V S-Meter adjust, W4QG |
| Next by Thread: | [TenTec] Jupiter - No transmit power output 10 meters, Karl Heimbach |
| Indexes: | [Date] [Thread] [Top] [All Lists] |