Re: [TenTec] OMNI C Mixer or PTO problem

[Michael Silevitch <msilevitch@coe.neu.edu>]

Dear Scott

R23 is the level adjust pot on the Oscillator-mixer board. I think that's
the one you are referring to. The manual only makes a passing reference to
it when describing setting the balance in the mixer. Is this the pot you
are referring to? Any other thoughts? The reason I ask is that the problem
arose as a result of shipping. It's not clear whether the pot would be
moved out of adjustment due to the vibration etc.

Regards
         Mike K1PEV



On 2/20/12 10:14 AM, "scottsheppard@videotron.ca"
<scottsheppard@videotron.ca> wrote:

>I think I may be able to help on  this having spent  a LOT of time inside
>the OMNI...adjust the thumbwheel POT on the mixer/vfo board--it will
>ensure you are sending enough signal to stay on freq and send it to your
>counter...I am not near teh radio but I think it was referred to as
>adjustment level or something...  let me know.  scott  VA3IED
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec