| To: | "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni C |
| From: | "Rick - DJ0IP / NJ0IP" <Rick@DJ0IP.de> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 21 Feb 2012 08:36:16 +0100 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
PIN 2 is "T"
PIN 6 is "C1" ("common" of the spst relay)
There is no jumper required.
There is no VFO signal or connection on that jack which needs to be enabled
or disabled.
It would be nice if there were, but unfortunately the problem is elsewhere.
73
Rick, DJ0P
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of GARY HUBER
Sent: Tuesday, February 21, 2012 5:16 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni C
What are socket pins 2 and 6 ?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Omni PTO rebuild--different grease, scottsheppard |
|---|---|
| Next by Date: | Re: [TenTec] Omni C mixer PTO problem, Rick - DJ0IP / NJ0IP |
| Previous by Thread: | Re: [TenTec] Omni C, GARY HUBER |
| Next by Thread: | Re: [TenTec] Omni C, GARY HUBER |
| Indexes: | [Date] [Thread] [Top] [All Lists] |