Download the 243 manual for the pinout and clues....
-----Original Message-----
From: Rick - DJ0IP / NJ0IP
Sent: Tuesday, February 21, 2012 1:36 AM
To: 'Discussion of Ten-Tec Equipment'
Subject: Re: [TenTec] Omni C
PIN 2 is "T"
PIN 6 is "C1" ("common" of the spst relay)
There is no jumper required.
There is no VFO signal or connection on that jack which needs to be enabled
or disabled.
It would be nice if there were, but unfortunately the problem is elsewhere.
73
Rick, DJ0P
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of GARY HUBER
Sent: Tuesday, February 21, 2012 5:16 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni C
What are socket pins 2 and 6 ?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|