Thanks so much Mike. I will try that this evening.
Joe
----- Original Message -----
From: "Mike Bryce" <prosolar@sssnet.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, February 23, 2012 9:14 AM
Subject: Re: [TenTec] Argosy Latching Switch
> Joe,
>
> There is a small spring that rides in a grove on the top of the switch.
> Just lift the spring ( looks like a piece of stiff wire) out of the
> groove.
>
> DON'T rip it out jut pull it from the groove. That way you can revert it
> back to latching if need be
>
> Mike wb8vge
>
> Sent from my iPhone
>
> On Feb 23, 2012, at 9:44 AM, "Joe" <joe@n4yg.com> wrote:
>
>> Does anyone know how to turn the pushbutton switches used in the Argosy
>> into non-latching momentarry switches?
>>
>> Joe
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|