This is a update on the problem listed below. I began trying to figure out
the problem with the O2. I notice the led lights on front of the rig would
dim and almost go out. I tap on the rig and the led light would brighten up
to normal and all would start back working.
I took the front panel off the rig and try to find a loose connetion. I
finally decided it was the short cable that goes to the little board on the
display. I could not get it unplugged until I took the front of the rig
apart. I took it apart and unplug the cable to the display and plugged it
back in place. Now the Orion II seem to work just fine.I should have plugged
it on and off a few times so maybe it would make a good contact. May it
will work for a while.(I had to take the front of the rig apart twice
because the ribbon to the display came loose while I was trying to get back
together the first time. When I turn the rig on all I got was a white lite
up display. So I took it a part a second time and was a little more careful
when I put it back together.)
N5II
Bill
----- Original Message -----
From: "Bill Sale" <n5ii@centurytel.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, February 23, 2012 10:01 PM
Subject: [TenTec] Orion II - front panel all will not work.
I have had problems with this orion for quite a while. None of the knob or
buttons will work on the Orion II. When I power up the rig with just the
on and off switch on the rig and when it comes on it says at bottom "FLASH
UPDATE MODE". Now anything I try it comes up with 'FLASH UPDATE MODE". I
was having problems 2 weeks or so with the front knobs or button not
working. So I unplug everything going to the rig and moved it to a table
and plugged the power supply back in and turned the rig on and it started
working. A day or so ago I upgraded to 3.028.
the rig has not worked since. I donot think 3.028 has anything to do with
the rig not working right. I cannot get the radio to reload 3.028 or
anything into the rig. It seems like the more I work with the rig tonite
the worse it gets. Early tonite the rig was booting up with no control
from the front controls, but now it will not go pass "FLASH UPDATE MODE".
The other day when the fron knobs had no control of the rig, I tried N4PY
soft ware and it seem to control the rig along with the read out. I just
tried N4PY and it has no control on the rig since if always come up with
"FLASH UPDATE MODE" on the screen. This rig has quite a history of
problems. I guess I will call Ten Tec and see what they say. It seems to
me something locks the radio up in the software area. When it is working
right I use Windows 7 and XP and Writelog. Any idears.
Thanks
N5II
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|