I don't think that indicates a problem.
I have two CorsairIIs - one of them "turns off" at 7.5 on the RF Gain,
and the other one at 4.
73,
Steve G3TXQ
On 22/03/2012 00:46, Russ Straate wrote:
Group. Thanks for the feedback on the RF Gain. It appears I have a
problem with my rig. The RF gain only operates over a very narrow range
when rotating the control. At about the 6 marking on the dial, the signal
disappears. The receiver appears to be fine with when wide open so it does
not appear that the receiver level is low. I have checked the pot with the
wires disconnected an it shows the 10K ohm range as it should. Any
thoughts on where else I should look?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|