Re: [TenTec] Receiver model 546

To:	"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject:	Re: [TenTec] Receiver model 546
From:	"Mike Hyder - N4NT" <Mike_N4NT@charter.net>
Reply-to:	Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date:	Fri, 20 Apr 2012 20:45:03 -0400
List-post:	<tentec@contesting.com">mailto:tentec@contesting.com>

If you can wiggle the bandswitch and get the receiver to come back on, 
perhaps cleaning it will help.

Mike N4NT

----- Original Message ----- 
From: "Barbara" <iloveantennas@dishmail.net>
To: <tentec@contesting.com>
Sent: Thursday, October 28, 2010 10:17 AM
Subject: [TenTec] Receiver model 546


> On the 80 meter range  occasionally the frequency reads 1.000 mhz and 
> rec,,goes dead.  Back on later. Only 80 meter range is affected.  Any 
> ideas thanks jjdavis

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread]	Current Thread	[Next in Thread>
[TenTec] Receiver model 546, Barbara Re: [TenTec] Receiver model 546, Mike Hyder - N4NT <=

Previous by Date:	[TenTec] TEN-TEC shack photos, Jim Wharton
Next by Date:	[TenTec] Fw: Receiver model 546, Mike Hyder - N4NT
Previous by Thread:	[TenTec] Receiver model 546, Barbara
Next by Thread:	[TenTec] Hercules II 10 Meter band pass board? Info?, David Perrin
Indexes:	[Date] [Thread] [Top] [All Lists]