It used to work Bob, but I'm a confirmed knob and switch fiddler.
John de VK2XGJ
You're all jealous because the voices
only speak to me!
-----Original Message-----
From: g3ory@lineone.net
Sent: Wednesday, April 25, 2012 6:01 PM
To: tentec@contesting.com
Subject: Re: [TenTec] Orion566 updating
John,
Does the CAT work from the computer you are using to the Orion? If
not, I suggest you check that it does before going back to the update.
Bob G3ORY
----Original Message----
From: jrsimon@ozemail.com.au
Date: 25/04/2012 6:55
To: "Discussion of Ten-Tec Equipment"<tentec@contesting.com>
Subj: [TenTec] Orion566 updating
I've been trying to update my OII from 2.044a to 3.029 using
an RS232-USB
cable and the radio can't/won't recognise the computer is connected.
I've
tried two computers, Win 7 and WIN XP.
Holding User 2 and switching on as per the manual until "FLASH UPDATE
MODE"
is showing, on release of User 2 button the radio then shows "Press
any key
to Exit".
I've tried two different RS232-USB cables with the same result.
I've even tried speaking to it in a foreign language that is full of
four-letter words but still nothing.
Aside from test flying the OII out the window, any suggestions?
John de VK2XGJ
You're all jealous because the voices
only speak to me!
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|