Hey OLE buddy,
I don't know how the mix up occurred but here you have K7TED and I don't
have any of the gear that you are talking about. Must be another TED
Thanks for the email anyway K7TED
In a message dated 5/30/2012 2:11:36 P.M. Pacific Daylight Time,
ky5rtim@gmail.com writes:
Hey Ted;
I use a relay interface box that used to be made by Array Solutions. It
provides
relay isolation between the O2 and the Dunestar 600 (switching +12Vdc to
the filter).
I didn't have to install jumpers in the Dunestar 600 for negative keying.
Saying that it appears this product is no longer available though you may
want check with AS.
The connectors for the BD output are an AMP series. One connector comes
with
each new radio so I assume you have a used unit. I think there has been
some info on this reflector for a P/N and a supplier(Mouser I believe).
I have two Orions configured with the Dunestar 600. It allows Multi-op
operation with no headaches. Working now on 2nd harmonic suppression
for CW weekends.
If you can't find I have a few spares and can part with one.
Email me direct if you can't find the info.......
GA Tim, Ky5r
On Wed, May 30, 2012 at 11:15 AM, Ted Bryant <W4NZ@comcast.net> wrote:
>
> Can someone please tell me what type of connector is used for the band
data
> outputs? Can't find it in the manual or on the website.
>
> Any suggestions on connecting a Dunestar model 600 to the Orion?
>
> Thanks!
>
> 73, Ted W4NZ
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|