Maybe this manual will help. You can always measure the voltage across the
lamp to see what it is .
73
Jim Younce K4ZM
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Curt
Sent: Friday, September 28, 2012 9:55 AM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] 252M Output Lamp Question
Curious what lamp is being used to replace the output lamp on older TT power
supplies. Factory just told me they are no longer made. I'm thinking they
are 14V, 6mm diameter bulbs with wire leads attached. Before I order from
Mouser, thought would ask.
73, Curt KB5JO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|