| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Adding Pilot Light to RX-320D |
| From: | Richards <jruing@ameritech.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 29 Sep 2012 20:28:30 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
THANK YOU for the detailed explanation ! I think I can do that! I will have my local electronics guru/ham Elmer look my work over before I power it up, just to be sure I follow the directions correctly. Thanks, again. =============== James - K8JHR ============= On 9/29/2012 8:22 AM, Charles P. Steinmetz wrote: You need a power supply, an LED, and a current limiting resistor. Typically, you use a push-in plastic bezel to mount the LED to the panel. The schematic shows ========================================== _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] hsmfest, John Molenda |
|---|---|
| Next by Date: | Re: [TenTec] Headset connection, Richards |
| Previous by Thread: | Re: [TenTec] Adding Pilot Light to RX-320D, James Duffer |
| Next by Thread: | Re: [TenTec] Adding Pilot Light to RX-320D, Mike Bryce |
| Indexes: | [Date] [Thread] [Top] [All Lists] |