Mike,
Before blaming the filter try tuning around and/or move the passband tuning
control (PBT) back and forth a bit. The 282 has an extremely narrow peak and
can sound like there's nothing there if you're not tuned in correctly on the
signal and/or properly centered on the passband. (Personal experience
here....)
73 es GL, Al
On Fri December 7 2012 12:51:16 pm Silevitch, Michael wrote:
> Does anyone have any insight into problems (and solutions) that would cause
> failure in a Ten Tec model 282 (or any other similar model) crystal filter?
> When the unit is plugged into its slot (on a Corsair) we get no response.
> Our next step is to test it on a network analyzer but I felt it would be
> worthwhile to also get inputs from people on the reflector.
>
> Regards,
> Mike K1PEV
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|