If the lower and upper cutoff freqs are both shifted higher, then my
guess is that you need to align the BFO oscillator trimmers.
73,
Barry N1EU
On Tue, Dec 11, 2012 at 5:31 PM, Paul Kraemer <elespe@lisco.com> wrote:
> Thanks Barry
> Very informative
> I also noted from a quick power bandwidth sweep done while I had the rig on
> the bench to replace a failed dc/dc chip powering the dsp that my
> transmitted USB singnal bandwidth is shifted higher by about 200 hz from
> what it is on LSB. Is that sumething that can be pulled or is it probably
> the USB crystal?
> Paul
>
> ----- Original Message ----- From: "Barry N1EU" <barry.n1eu@gmail.com>
>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Monday, December 10, 2012 11:01 AM
> Subject: Re: [TenTec] OMNI VI
>
>
>
>> Please see http://www.tentecwiki.org/doku.php?id=563ssbaud
>>
>> 73,
>> Barry N1EU
>>
>> On Mon, Dec 10, 2012 at 1:24 AM, <elespe@lisco.com> wrote:
>>>
>>> Has anyone installed the $15 INRAD receive audio modification?
>>> Results? Opinions?
>>> Paul K0UYA
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|