Hello to all, Got an easy question.. Been all thru the manual, and can’t find
the type of vacuum relay used in it.. When I switch to “Operate” the RX signal
goes away most of the time.. Then, if I put out a little signal for tune up the
RX signal comes back, and all is fine after that.. I’m just suspecting vacuum
relay contacts??
I can use it as is..
I have a spare relay for my Hercules II, and hope the 425 might use the same
one.. But, before I take it of service or call TT, I would like to make sure I
have the right relay on hand.. HEY, I worked SCL “Santa Claus Land”
yesterday on 20M RTTY, HO HO HO “TEN TEC FOREVER AND RTTY TOO”
Merry Christmas to all and a HNY
73,
Harry N Coates
WA8HC1@charter.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|