John,
1st - Merry Christmas and a Happy
New Year to you and yours!
2nd - Thanks for this update, will
give it a test very soon.
73 de Billy AA4NU
-----Original Message-----
>From: John Henry
>Sent: Dec 20, 2012 9:50 PM
>To: Discussion of Ten-Tec Equipment
>Subject: [TenTec] Orion II Model 566 Version 3.033xa posted
>
>Just posted an update on the TenTec web page for the Orion II Model 566.
>
>Version 3.033xa December 20, 2012
>Added S-Meter Calibration
> The procedure is downloaded with the 3.033xa update, There is a
>start-menu link. e.g. in
> Windows, click on Start, All-Programs, Ten-Tec, OrionII Firmware
>Update, then look for the file
> S-Meter 565 566 Calibration Procedure
>Corrected Sweep alignment in LSB
>Corrected SAF/Notch setting after power up.
>
>The procedure is not necessary, but allows those that want the S-Meter
>readout to be as exact as they can get it, they can adjust it. It is
>actually adjusting the voltage level to the meter, e.g. when the
>software detects an S-9, it will look up the value in this table and
>use it to drive the meter. It does not adjust what is read by the
>software, an S9 is still an S9 in the software.
>
>
>--
>==============================================
>John Henry, KI4JPL Phone: 865-453-7172 x234
>Engineering Direct: 865-868-4915
>TenTec, Inc. Fax: 865-428-4483
>1185 Dolly Parton Parkway
>Sevierville, TN 37862
>www.tentec.com E-Mail: jhenry@tentec.com
>==============================================
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|