I have recently acquired and Omni VI. The rig has seen little use in the last
10 years but it is working VERY well with a minor exception. The rig is
slightly off frequency (about 150 Hz) - even after a significant warm-up.
Looking at the schematic, I have found the crystal oven on the Logic Board
(81606). It looks like the crystal frequency can be tweaked with C31. This is
an early O-6 and it has the crystal oven.
Other than C31, are there any other adjustments I should be considering?
Thanks.
73,
Rick
VE7TK
Website: http://www.ve7tk.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|