TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] eagle n1mm cw config

from [Robert Mcgraw] [Permanent Link][Original]
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] eagle n1mm cw config
From: "Robert Mcgraw" <rmcgraw@blomand.net>
Reply-to: rmcgraw@blomand.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 13 Jan 2013 11:52:49 -0600 (CST)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com> 
For CW I typically use the MCW mode.

73
Bob, K4TAX

> I have the rig control working. MMTTY with 712 soundcard interface works.
> But, I cannot get CW to work with N1MM. Anybody have it working? What
> settings work?
>
> Thanks,
> Nathan, KF9LI
> TenTec Eagle
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  [TenTec] TEN-TEC 40 Meter & 20 Meter Nets Today (Sunday), John Occhipinti
Next by Date:  Re: [TenTec] WTB: Older Jupiter, Richards
Previous by Thread:  [TenTec] eagle n1mm cw config, Nathan Gordon
Next by Thread:  Re: [TenTec] eagle n1mm cw config, Ted Bryant
Indexes:  [Date] [Thread] [Top] [All Lists]