N1MM does not support MCW.
73, Ted W4NZ
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Robert
Mcgraw
Sent: Sunday, January 13, 2013 12:53 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] eagle n1mm cw config
For CW I typically use the MCW mode.
73
Bob, K4TAX
> I have the rig control working. MMTTY with 712 soundcard interface works.
> But, I cannot get CW to work with N1MM. Anybody have it working? What
> settings work?
>
> Thanks,
> Nathan, KF9LI
> TenTec Eagle
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|