Also likely means that the SWR is 3:1 or higher and that the reactive
component of the Z is much less than 50 ohms. Maybe in the order of 15 ohms
or so.
Anyway, Carl is correct in that the shut-down protection circuit is about to
become active and shut the radio down.
73
Bob, K4TAX
----- Original Message -----
From: "Carl Moreschi" <n4py3@earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, March 13, 2013 9:21 PM
Subject: Re: [TenTec] High current
It means that your current in the finals is very near the point where the
radio will shut down.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 3/13/2013 10:09 PM, John Molenda wrote:
can anyone tell me the meaning of the High current flashing on the
screen of my omni vii on cw . thanks John kb2huk
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|