Re: [TenTec] Adapting a Kenwood mic to Ten Tec Scout

[Stuart Rohre <rohre@arlut.utexas.edu>]

A couple of corrections in my post "mail" should be male.

the impedance change is done where the mike cable plugs into the Kenwood 
mike tube, not on the desk base itself.  Just ignore if you were not 
asking about a desk mike converting to a Scout.
Stuart
K5KVH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec