To: | tentec@contesting.com |
---|---|
Subject: | [TenTec] OMNI VI no TX |
From: | Don Jones <ko7i@comcast.net> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Sun, 22 Sep 2013 06:37:05 -0700 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
With the RF power set to 12 o'clock and then selecting tune I normally
get 5 to 10W out for tuning my antenna. I am getting no output, the ALC
LED is lite, and when selecting final current it is very high and the
heat sink on the power supply gets warm.
Not sure what to make of this, blown finals? Advice welcome. 73, Don _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Value of RX Only Antennas, Mark Luhrman |
---|---|
Next by Date: | [TenTec] Paragon power problem, Vic Klein |
Previous by Thread: | Re: [TenTec] TenTec Digest, Vol 129, Issue 17, Dave Garner |
Next by Thread: | [TenTec] Paragon power problem, Vic Klein |
Indexes: | [Date] [Thread] [Top] [All Lists] |