It is one of the 4 filters on the Band Pass Board located on the bottom side
of the transceiver. There's slots for 0.25 KHz, 0.5 KHz, 1.8 KHz, and 2.4
KHz. The 6 KHz is a network and not a physical filter.
73
Bob, K4TAX
----- Original Message -----
From: "Basilie Bill Actipis" <N1ASS@speedconnect.com>
To: <tentec@contesting.com>
Sent: Saturday, September 28, 2013 1:36 PM
Subject: [TenTec] Paragon II model 586,
Has anybody out there have put the inrad 2.8khz SSB filter in their
paragon for TX????????
Where is the TX SSB filter is located??????
How can I identify the filter because one is the 6khz AM filter?????
I know I can use the 6khx AM filter for RX,but I will also install one for
RX.
Thank you in advance for the help.Bill / N1ASS.73..............
--
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|