[TenTec] Discussion of Ten-Tec Equipment Paragon II clock.

["Mark Kenward" <k8vf_mark@centurytel.net>]

My clock in Paragon II was acting goofy, wierd symbols, clock quit each time I 
shut off rig, so I located a chip-DS 1287A+  which was purported to be direct 
replacement.

Installed it, KNOWING it had an additional pin(reset) as board had a spot for 
it.

Clock now acts as a run time counter.  Starts back up at whatever time was when 
rig was shut off.

I clipped the reset pin off, and verified no contact , with same results.


Anyone have an idea on this one?

thanks,

Mark
K8VF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec